in return value not in errno.

_thr_leave_cancellation_point to _thr_cancel_leave, add a parameter
to _thr_cancel_leave to indicate whether cancellation point should be
checked, this gives us an option to not check cancallation point if
a syscall successfully returns to avoid any leaks, current I have
creat(), open() and fcntl(F_DUPFD) to not check cancellation point
after they sucessfully returned.

Replace some members in structure kse with bit flags to same some
memory.

Conditionally compile THR_ASSERT to nothing if _PTHREAD_INVARIANTS is
not defined.

Inline some small functions in thr_cancel.c.

Use __predict_false in thr_kern.c for some executed only once code.

Reviewd by: deischen

yet, so we can protect some locking code from being interrupted by signal
handling. When KSE mode is turned on, reset the thread flag to scope process
except we are running in 1:1 mode which we needn't turn it off.
Also remove some unused member variables in structure kse.

Tested by: deischen

Reviewed by: deischen

  is system bound thread and when it is blocked, no upcall is generated.

o Add ability to libkse to allow it run in pure 1:1 threading mode,
  defining SYSTEM_SCOPE_ONLY in Makefile can turn on this option.

o Eliminate code for installing dummy signal handler for sigwait call.

o Add hash table to find thread.

Reviewed by: deischen

its waitset, but if the signal is not masked by the thread, the signal
can interrupt the thread and signal action can be invoked by the thread,
sigwait should return with errno set to EINTR.
Also save and restore thread internal state(timeout and interrupted)
around signal handler invoking.

outside of lock.

use [signal number - 1] as subscript to access the array.

  signals were changed in kernel, it will retrieve the pending set and
  try to find a thread to dispatch the signal. The dispatching process
  can be rolled back if the signal is no longer in kernel.

o Create two functions _thr_signal_init() and _thr_signal_deinit(),
  all signal action settings are retrieved from kernel when threading
  mode is turned on, after a fork(), child process will reset them to
  user settings by calling _thr_signal_deinit(). when threading mode
  is not turned on, all signal operations are direct past to kernel.

o When a thread generated a synchoronous signals and its context returned
  from completed list, UTS will retrieve the signal from its mailbox and try
  to deliver the signal to thread.

o Context signal mask is now only used when delivering signals, thread's
  current signal mask is always the one in pthread structure.

o Remove have_signals field in pthread structure, replace it with
  psf_valid in pthread_signal_frame. when psf_valid is true, in context
  switch time, thread will backout itself from some mutex/condition
  internal queues, then begin to process signals. when a thread is not
  at blocked state and running, check_pending indicates there are signals
  for the thread, after preempted and then resumed time, UTS will try to
  deliver signals to the thread.

o At signal delivering time, not only pending signals in thread will be
  scanned, process's pending signals will be scanned too.

o Change sigwait code a bit, remove field sigwait in pthread_wait_data,
  replace it with oldsigmask in pthread structure, when a thread calls
  sigwait(), its current signal mask is backuped to oldsigmask, and waitset
  is copied to its signal mask and when the thread gets a signal in the
  waitset range, its current signal mask is restored from oldsigmask,
  these are done in atomic fashion.

o Two additional POSIX APIs are implemented, sigwaitinfo() and sigtimedwait().

o Signal code locking is better than previous, there is fewer race conditions.

o Temporary disable most of code in _kse_single_thread as it is not safe
  after fork().