Remove /^[\s*]*__FBSDID\("\$FreeBSD\$"\);?\s*\n/
Refactor to eliminate duplicated rate and delay tables, with minor style tweaks for changed lines. Remove an obsolete comment about needing to convert from microseconds to ticks (that's done elsewhere). Remove traiing whitespace in kbdcontrol.c. Except for the new warning, no change in behavior Sponsored by: DSS GmbH Reviewed by: imp [minor style tweaks as well] Pull Request: https://github.com/freebsd/pull/683 Differential Revision: https://reviews.freebsd.org/D38818
The SPDX folks have obsoleted the BSD-2-Clause-NetBSD identifier. Catch up to that fact and revert to their recommended match of BSD-2-Clause. Discussed with: pfg MFC After: 3 days Sponsored by: Netflix
FreeBSD-9 had introduced support for the full set of Unicode characters to the parsing and processing of keymap character tables. This support has been extended to cover the table for accented characters that are reached via dead key combinations in FreeBSD-13.2. New ioctls have been introduced to support both the pre-Unicode and the Unicode formats and keyboard drivers have been extended to support those ioctls. This commit makes the ABI compatibility functions in the kernel optional and dependent on COMPAT_FREEBSD13 in -CURRENT. The kbdcontrol command in -CURRENT and 13-STABLE (before 13.2) has been made ABI compatible with old kernels to allow a new world to be run on an old kernel (that does not have full Unicode support for keymaps). This commit is not to merged back to 12-STABLE or 13-STABLE. It is part of review D38465, which has been split into 3 separate commits due to different MFC and life-time requirements of either commit. Approved by: imp Differential Revision: https://reviews.freebsd.org/D38465
Support for Unicode characters had been added to the keyboard code, but there are keymaps that have accented characters accessed via dead key combinations, and those were still restricted to 8 bit codes. This update to kbd.c adds support for Unicode characters and compatibility code that allows a kbdcontrol command built from kbio.h without these patches to work on a new kernel. Compatibility code that allows a new kbdcontrol binary running on an old kernel to load and display the dead key map will be committed in a separate commit. Reviewed by: imp, brooks Approved by: brooks MFC after: 3 days Differential Revision: https://reviews.freebsd.org/D38381
of various keyboard drivers. EVIOCGRAB ioctl execution on /dev/input/event# device node gains exclusive access to this device to caller. It is used mostly for development purposes and remote control software. See e.g. https://reviews.freebsd.org/D30020 which is the reason of creation of this change. Keyboard grabbing is disabled in KDB and during panics. MFC with: 4a0db5e2920c Tested by: corvink Differential revision: https://reviews.freebsd.org/D30542
Ignore fantom keyboard state reports entirelly rather than ignore RollOver states for each key separatelly. Latter results in spurious release/push pairs of events on each fantom keyboard state report. Reported by: Jan Martin Mikkelsen <janm_AT_transactionware_DOT_com> Submitted by: Jan Martin Mikkelsen (initial version) PR: 253249 MFC after: 1 week
usbhid(4) is disabled by default to avoid conflicts with existing USB HID drivers. To enable it place following lines to /boot/loader.conf: hw.usb.usbhid.enable=1 usbhid_load="YES" Suggested by: jhb Reviewed by: hselasky Differential revision: https://reviews.freebsd.org/D28124
This change implements hid_if.m methods for HID-over-USB protocol [1]. Also, this change adds USBHID_ENABLED kernel option which changes device_probe() priority and adds/removes PnP records to prefer usbhid over ums, ukbd, wmt and other USB HID device drivers and vice-versa. The module is based on uhid(4) driver. It is disabled by default for now due to conflicts with existing USB HID drivers. [1] https://www.usb.org/sites/default/files/hid1_11.pdf Reviewed by: hselasky Differential revision: https://reviews.freebsd.org/D27893