pkg_add has been gone since 2013(?).  Refer to pkg(8) instead.

Sponsored by:	The FreeBSD Foundation
MFC after:	3 days
Reviewed by:	jrtc27
Differential Revision: https://reviews.freebsd.org/D44946

Remove /^\s*#[#!]?\s*\$FreeBSD\$.*$\n/

Add Indonesian Documentation to docinstall menu.

Approved by:	doceng (implicit) re (gjb, implicit)
MFC after:	1 week

Approved by:		allanjude, asiciliano
Differential Revision:	https://reviews.freebsd.org/D35197
Sponsored by:		Rubicon Communications, LLC ("Netgate")

package entry.

Approved by:	re (gjb)
MFC after:	1 week

MFC after:	3 days
X-MFC-to:	stable/10

MFC after:	3 days
X-MFC-to:	stable/10

Reviewed by:	bapt
Approved by:	dteske
Sponsored by:	ScaleEngine Inc.

bsdconfig's f_package_add doesn't seem to support using the pkg repo from /etc/pkg/FreeBSD.conf, it also tries to run the commands on the installer image, not in the destination chroot

Instead, manually bootstrap pkg in the chroot, and then install the requested packages (in the chroot)

Doesn't use pkg -c, because pkg is not installed on the installer image

PR:		196250
Differential Revision:	https://reviews.freebsd.org/D2026
Approved by:	bapt
Sponsored by:	ScaleEngine Inc.

that the slightly older dialog(1) requires --separate-output when using the
--checklist widget to force response to produce unquoted values (whereas in
stable/10 --checklist widget without --separate-output will only quote the
checklist labels in the response if the label is multi-word (contains any
whitespace).

Since these enhancements (see revisions 263956 and 264437) were developed
originally on 10, the --separate-output option was omitted. When merged to
stable/9, we (Allan Jude) and I found during testing that the "always-
quoting" of the response was causing things like struct interpolation to
fail (`f_struct device_$dev' would produce `f_struct device_\"da0\"' for
example -- literal quotes inherited from dialog(1) --checklist response).

To see the behavior, execute the following on stable/9 versus stable/10:

        dialog --checklist disks: 0 0 0 da0 "" off da1 "" off

Check both items and hit enter. On stable/10, the response is:

        da0 da1

On stable/9 the response is:

        "da0" "da1"

If you use the --separate-output option, the response is the same for both:

        da0
        da1

So applying --separate-output on every platform until either one of two
things occurs 1) dialog(1,3) gets synchronized between stable/9, higher or
2) we drop support for stable/9.

MFC after:      3 days
Reviewed by:    Allan Jude