Remove a pre-5.3 note, language fixes, and add a missing </sect2>.

Approved by:	remko (mentor)
Obtained from:	perforce
No objections from:	-doc

1 files changed, 4 insertions, 9 deletions

diff --git a/en_US.ISO8859-1/books/handbook/mac/chapter.sgml b/en_US.ISO8859-1/books/handbook/mac/chapter.sgml
index f7d63a8a01..509924cecb 100644
--- a/en_US.ISO8859-1/books/handbook/mac/chapter.sgml
+++ b/en_US.ISO8859-1/books/handbook/mac/chapter.sgml
@@ -967,12 +967,6 @@ test: biba/high</screen>
 
       <screen>&prompt.root; <userinput>ugidfw add subject not uid root new object not uid root mode n</userinput></screen>
 
-      <note>
-	<para>In releases prior to &os;&nbsp;5.3, the
-	  <parameter>add</parameter> parameter did not exist.  In those
-	  cases the <parameter>set</parameter> should be used
-	  instead.  See below for a command example.</para></note>
-
       <para>This is a very bad idea as it will block all users from
 	issuing even the most simple commands, such as
 	<command>ls</command>.  A more patriotic list of rules
@@ -1427,6 +1421,7 @@ test: biba/high</screen>
 	company information, and financial institution environments.
 	The most unlikely place would be a personal workstation with
 	only two or three users.</para>
+    </sect2>
   </sect1>
 
   <sect1 id="mac-biba">
@@ -1887,7 +1882,7 @@ setpmac biba/10\(10-10\) /usr/local/etc/rc.d/nagios.sh forcestart</userinput></s
       &man.mac.seeotheruids.4; could co-exist and block access not
       only to system objects but to hide user processes as well.
 
-    <para>Begin by adding the following lines to
+    <para>Begin by adding the following line to
       <filename>/boot/loader.conf</filename>:</para>
 
     <programlisting>mac_seeotheruids_enabled="YES"</programlisting>
@@ -2032,9 +2027,9 @@ setpmac biba/10\(10-10\) /usr/local/etc/rc.d/nagios.sh forcestart</userinput></s
     <sect2>
       <title>Error: &man..secure.path.3; cannot stat <filename>.login_conf</filename></title>
 
-      <para>When I attempt to switch from the <username>root</username>
+      <para>When I attempt to switch from the <username>root</username> user
 	to another user in the system, the error message
-	<errorname>_secure_path: unable to state .login_conf</errorname>.</para>
+	<errorname>_secure_path: unable to state .login_conf</errorname> appears.</para>
 
       <para>This message is usually shown when the user has a higher
 	label setting then that of the user whom they are attempting to