diff options
Diffstat (limited to 'Bindings/usb/msm-hsusb.txt')
-rw-r--r-- | Bindings/usb/msm-hsusb.txt | 15 |
1 files changed, 15 insertions, 0 deletions
diff --git a/Bindings/usb/msm-hsusb.txt b/Bindings/usb/msm-hsusb.txt index 2826f2af503a..8654a3ec23e4 100644 --- a/Bindings/usb/msm-hsusb.txt +++ b/Bindings/usb/msm-hsusb.txt @@ -52,6 +52,10 @@ Required properties: Optional properties: - dr_mode: One of "host", "peripheral" or "otg". Defaults to "otg" +- switch-gpio: A phandle + gpio-specifier pair. Some boards are using Dual + SPDT USB Switch, witch is cotrolled by GPIO to de/multiplex + D+/D- USB lines between connectors. + - qcom,phy-init-sequence: PHY configuration sequence values. This is related to Device Mode Eye Diagram test. Start address at which these values will be written is ULPI_EXT_VENDOR_SPECIFIC. Value of -1 is reserved as @@ -69,6 +73,17 @@ Optional properties: (no, min, max) where each value represents either a voltage in microvolts or a value corresponding to voltage corner. +- qcom,manual-pullup: If present, vbus is not routed to USB controller/phy + and controller driver therefore enables pull-up explicitly + before starting controller using usbcmd run/stop bit. + +- extcon: phandles to external connector devices. First phandle + should point to external connector, which provide "USB" + cable events, the second should point to external connector + device, which provide "USB-HOST" cable events. If one of + the external connector devices is not required empty <0> + phandle should be specified. + Example HSUSB OTG controller device node: usb@f9a55000 { |