blob: d786a7dedaf4c43e8858f777318a75d8837f7ea1 (
plain) (
blame)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
|
.. _how_to_build_on_arm:
===================================================================
How To Build On ARM
===================================================================
.. sectionauthor:: Wei-Ren Chen (陳韋任) <chenwj@iis.sinica.edu.tw>
Introduction
============
This document contains information about building/testing LLVM and
Clang on ARM.
Notes On Building LLVM/Clang on ARM
=====================================
Here are some notes on building/testing LLVM/Clang on ARM. Note that
ARM encompasses a wide variety of CPUs; this advice is primarily based
on the ARMv6 and ARMv7 architectures and may be inapplicable to older chips.
#. If you are building LLVM/Clang on an ARM board with 1G of memory or less,
please use ``gold`` rather then GNU ``ld``.
Building LLVM/Clang with ``--enable-optimized``
is prefered since it consumes less memory. Otherwise, the building
process will very likely fail due to insufficient memory. In any
case it is probably a good idea to set up a swap partition.
#. If you want to run ``make
check-all`` after building LLVM/Clang, to avoid false alarms (eg, ARCMT
failure) please use at least the following configuration:
.. code-block:: bash
$ ../$LLVM_SRC_DIR/configure --with-abi=aapcs-vfp
#. The most popular linaro/ubuntu OS's for ARM boards, eg, the
Pandaboard, have become hard-float platforms. The following set
of configuration options appears to be a good choice for this
platform:
.. code-block:: bash
./configure --build=armv7l-unknown-linux-gnueabihf
--host=armv7l-unknown-linux-gnueabihf
--target=armv7l-unknown-linux-gnueabihf --with-cpu=cortex-a9
--with-float=hard --with-abi=aapcs-vfp --with-fpu=neon
--enable-targets=arm --disable-optimized --enable-assertions
|
