Remove single-space hard sentence breaks. These degrade the quality

of the typeset output, tend to make diffs harder to read and provide
bad examples for new-comers to mdoc.

1 files changed, 14 insertions, 7 deletions

diff --git a/share/man/man4/sk.4 b/share/man/man4/sk.4
index 731d78369c5f..5b0cfcd67e79 100644
--- a/share/man/man4/sk.4
+++ b/share/man/man4/sk.4
@@ -56,24 +56,29 @@ SK-9844 SK-NET GE-SX dual port, multimode fiber adapter
 .El
 .Pp
 The SysKonnect adapters consist of two main components: the XaQti Corp.
-XMAC II gigabit MAC and the SysKonnect GEnesis controller ASIC. The
+XMAC II gigabit MAC and the SysKonnect GEnesis controller ASIC.
+The
 XMAC provides the gigabit MAC and PHY suspport while the GEnesis
 provides an interface to the PCI bus, DMA support, packet buffering
-and arbitration. The GEnesis can control up to two XMACs simultaneously,
+and arbitration.
+The GEnesis can control up to two XMACs simultaneously,
 allowing dual-port NIC configurations.
 .Pp
 The
 .Nm
 driver configures dual port SysKonnect adapters such that each XMAC
-is treated as a separate logical network interface. Both ports can
+is treated as a separate logical network interface.
+Both ports can
 operate indepenently of each other and can be connected to separate
-networks. The SysKonnect driver software currently only uses the
+networks.
+The SysKonnect driver software currently only uses the
 second port on dual port adapters for failover purposes: if the link
 on the primary port fails, the SysKonnect driver will automatically
 switch traffic onto the second port.
 .Pp
 The XaQti XMAC II supports full and half duplex operation with
-autonegotiation. The XMAC also supports unlimited frame sizes.
+autonegotiation.
+The XMAC also supports unlimited frame sizes.
 Support for jumbo frames is provided via the interface MTU setting.
 Selecting an MTU larger than 1500 bytes with the
 .Xr ifconfig 8
@@ -93,7 +98,8 @@ the autoselected mode by adding media options to the
 .Pa /etc/rc.conf
 file.
 .It 1000baseSX
-Set 1000Mbps (gigabit ethernet) operation. Both
+Set 1000Mbps (gigabit ethernet) operation.
+Both
 .Ar full-duplex
 and
 .Ar half-duplex
@@ -125,7 +131,8 @@ A fatal initialization error has occurred.
 The driver failed to allocate memory for per-device instance information
 during initialization.
 .It "sk%d: failed to enable memory mapping!"
-The driver failed to initialize PCI shared memory mapping. This might
+The driver failed to initialize PCI shared memory mapping.
+This might
 happen if the card is not in a bus-master slot.
 .It "sk%d: no memory for jumbo buffers!"
 The driver failed to allocate memory for jumbo frames during