diff options
Diffstat (limited to 'sys/contrib/dev/iwlwifi/fw/api/mac-cfg.h')
| -rw-r--r-- | sys/contrib/dev/iwlwifi/fw/api/mac-cfg.h | 162 |
1 files changed, 155 insertions, 7 deletions
diff --git a/sys/contrib/dev/iwlwifi/fw/api/mac-cfg.h b/sys/contrib/dev/iwlwifi/fw/api/mac-cfg.h index b9f559dac39f..c7a833f8041a 100644 --- a/sys/contrib/dev/iwlwifi/fw/api/mac-cfg.h +++ b/sys/contrib/dev/iwlwifi/fw/api/mac-cfg.h @@ -66,6 +66,18 @@ enum iwl_mac_conf_subcmd_ids { */ TWT_OPERATION_CMD = 0x10, /** + * @NAN_CFG_CMD: &struct iwl_nan_config_cmd + */ + NAN_CFG_CMD = 0x12, + /** + * @NAN_DW_END_NOTIF: &struct iwl_nan_dw_end_notif + */ + NAN_DW_END_NOTIF = 0xf4, + /** + * @NAN_JOINED_CLUSTER_NOTIF: &struct iwl_nan_cluster_notif + */ + NAN_JOINED_CLUSTER_NOTIF = 0xf5, + /** * @MISSED_BEACONS_NOTIF: &struct iwl_missed_beacons_notif */ MISSED_BEACONS_NOTIF = 0xF6, @@ -420,6 +432,8 @@ struct iwl_mac_config_cmd { * eht_support set to true. No longer used since _VER_3 of this command. * @LINK_CONTEXT_MODIFY_BANDWIDTH: Covers iwl_link_ctx_cfg_cmd::modify_bandwidth. * Request RX OMI to the AP to modify bandwidth of this link. + * @LINK_CONTEXT_MODIFY_UHR_PARAMS: covers iwl_link_ctx_cfg_cmd::npca_params and + * iwl_link_ctx_cfg_cmd::prio_edca_params. Since _VER_7. * @LINK_CONTEXT_MODIFY_ALL: set all above flags */ enum iwl_link_ctx_modify_flags { @@ -432,6 +446,7 @@ enum iwl_link_ctx_modify_flags { LINK_CONTEXT_MODIFY_BSS_COLOR_DISABLE = BIT(6), LINK_CONTEXT_MODIFY_EHT_PARAMS = BIT(7), LINK_CONTEXT_MODIFY_BANDWIDTH = BIT(8), + LINK_CONTEXT_MODIFY_UHR_PARAMS = BIT(9), LINK_CONTEXT_MODIFY_ALL = 0xff, }; /* LINK_CONTEXT_MODIFY_MASK_E_VER_1 */ @@ -489,22 +504,36 @@ enum iwl_link_modify_bandwidth { }; /** + * enum iwl_npca_flags - NPCA flags + * @IWL_NPCA_FLAG_MAC_HDR_BASED: MAC header based NPCA operation + * permitted in the BSS (MOPLEN) + */ +enum iwl_npca_flags { + IWL_NPCA_FLAG_MAC_HDR_BASED = BIT(0), +}; /* NPCA_FLAG_E */ + +/** * struct iwl_npca_params - NPCA parameters (non-primary channel access) * + * @dis_subch_bmap: disabled subchannel bitmap for NPCA * @switch_delay: after switch, delay TX according to destination AP * @switch_back_delay: switch back to control channel before OBSS frame end + * @initial_qsrc: Indicates the value that is used to initialize the + * EDCAF QSRC[AC] variables * @min_dur_threshold: minimum PPDU time to switch to the non-primary - * NPCA channel - * @flags: NPCA flags - bit 0: puncturing allowed, bit 1: new TX allowed + * NPCA channel (usec) + * @flags: NPCA flags, see &enum iwl_npca_flags * @reserved: reserved for alignment purposes */ struct iwl_npca_params { + __le16 dis_subch_bmap; u8 switch_delay; u8 switch_back_delay; - __le16 min_dur_threshold; - __le16 flags; - __le16 reserved; -} __packed; /* NPCA_PARAM_API_S_VER_1 */ + u8 initial_qsrc; + u8 min_dur_threshold; + u8 flags; + u8 reserved; +} __packed; /* NPCA_PARAM_API_S_VER_2 */ /** * struct iwl_link_config_cmd - command structure to configure the LINK context @@ -615,7 +644,8 @@ struct iwl_link_config_cmd { struct iwl_npca_params npca_params; /* since _VER_7 */ struct iwl_ac_qos prio_edca_params; /* since _VER_7 */ __le32 reserved3[4]; -} __packed; /* LINK_CONTEXT_CONFIG_CMD_API_S_VER_1, _VER_2, _VER_3, _VER_4, _VER_5, _VER_6, _VER_7 */ +} __packed; /* LINK_CONTEXT_CONFIG_CMD_API_S_VER_1, _VER_2, _VER_3, _VER_4, + * _VER_5, _VER_6, _VER_7, _VER_8 */ /* Currently FW supports link ids in the range 0-3 and can have * at most two active links for each vif. @@ -987,4 +1017,122 @@ struct iwl_twt_operation_cmd { u8 ul_tid_bitmap; } __packed; /* TWT_OPERATION_API_S_VER_1 */ +enum iwl_nan_band { + IWL_NAN_BAND_5GHZ = 0, + IWL_NAN_BAND_2GHZ = 1, + IWL_NUM_NAN_BANDS, +}; + +/** + * struct iwl_nan_band_config - NAN band configuration + * + * @rssi_close: RSSI threshold for close proximity in dBm + * @rssi_middle: RSSI threshold for middle proximity in dBm + * @dw_interval: Discovery Window (DW) interval for synchronization beacons and + * SDFs. Valid values of DW interval are: 1, 2, 3, 4 and 5 corresponding to + * 1, 2, 4, 8, and 16 DWs. + * @reserved: reserved + */ +struct iwl_nan_band_config { + u8 rssi_close; + u8 rssi_middle; + u8 dw_interval; + u8 reserved; +}; /* NAN_BAND_SPECIFIC_CONFIG_API_S_VER_1 */ + +/** + * enum iwl_nan_flags - flags for NAN configuration + * + * @IWL_NAN_FLAG_DW_END_NOTIF_ENABLED: indicates that the host wants to receive + * notifications when a DW ends. + */ +enum iwl_nan_flags { + IWL_NAN_FLAG_DW_END_NOTIF_ENABLED = BIT(0), +}; + +/** + * struct iwl_nan_config_cmd - NAN configuration command + * + * @action: action to perform, see &enum iwl_ctxt_action + * @nmi_addr: NAN Management Interface (NMI) address + * @reserved_for_nmi_addr: reserved + * @discovery_beacon_interval: discovery beacon interval in TUs + * @cluster_id: lower last two bytes of the cluster ID, in case the local + * device starts a cluster + * @sta_id: station ID of the NAN station + * @hb_channel: channel for 5 GHz if the device supports operation on 5 GHz. + * Valid values are 44 and 149, which correspond to the 5 GHz channel, and + * 0 which means that NAN operation on the 5 GHz band is disabled. + * @master_pref: master preference + * @dwell_time: dwell time on the discovery channel during scan (milliseconds). + * If set to 0, the dwell time is determined by the firmware. + * @scan_period: scan period in seconds. If set to 0, the scan period is + * determined by the firmware. + * @flags: flags for NAN configuration, see &enum iwl_nan_flags + * @band_config: band configuration for NAN, one for each band + * @nan_attr_len: length of the NAN attributes to be added to the beacon (bytes) + * @nan_vendor_elems_len: length of the NAN vendor elements to be added to the + * beacon (bytes) + * @beacon_data: variable length data that contains the NAN attributes + * (&nan_attr_len) followed by the NAN vendor elements + * (&nan_vendor_elems_len). + */ +struct iwl_nan_config_cmd { + __le32 action; + u8 nmi_addr[6]; + __le16 reserved_for_nmi_addr; + __le32 discovery_beacon_interval; + + u8 cluster_id[2]; + u8 sta_id; + u8 hb_channel; + + u8 master_pref; + u8 dwell_time; + u8 scan_period; + u8 flags; + + struct iwl_nan_band_config band_config[IWL_NUM_NAN_BANDS]; + + __le32 nan_attr_len; + __le32 nan_vendor_elems_len; + u8 beacon_data[]; +} __packed; /* NAN_CONFIG_CMD_API_S_VER_1 */ + +/** + * enum iwl_nan_cluster_notif_flags - flags for the cluster notification + * + * @IWL_NAN_CLUSTER_NOTIF_FLAG_NEW_CLUSTER: indicates that the device has + * started a new cluster. If not set, the device has joined an existing + * cluster. + */ +enum iwl_nan_cluster_notif_flags { + IWL_NAN_CLUSTER_NOTIF_FLAG_NEW_CLUSTER = BIT(0), +}; /* NAN_JOINED_CLUSTER_FLAG_E_VER_1 */ + +/** + * struct iwl_nan_cluster_notif - event sent when the device starts or joins a + * NAN cluster. + * + * @cluster_id: the last two bytes of the cluster ID + * @flags: combination of &enum iwl_nan_cluster_notif_flags + * @reserved: reserved + */ +struct iwl_nan_cluster_notif { + u8 cluster_id[2]; + u8 flags; + u8 reserved; +}; /* NAN_JOINED_CLUSTER_NTF_API_S_VER_1 */ + +/** + * struct iwl_nan_dw_end_notif - sent to notify the host the end of a DW. + * + * @band: band on which the DW ended. See &enum iwl_nan_band. + * @reserved: reserved + */ +struct iwl_nan_dw_end_notif { + u8 band; + u8 reserved[3]; +} __packed; /* NAN_DW_END_NTF_API_S_VER_1 */ + #endif /* __iwl_fw_api_mac_cfg_h__ */ |