diff options
Diffstat (limited to 'sys/contrib/device-tree/Bindings/net/ethernet-phy.yaml')
| -rw-r--r-- | sys/contrib/device-tree/Bindings/net/ethernet-phy.yaml | 37 |
1 files changed, 37 insertions, 0 deletions
diff --git a/sys/contrib/device-tree/Bindings/net/ethernet-phy.yaml b/sys/contrib/device-tree/Bindings/net/ethernet-phy.yaml index d9b62741a225..71e2cd32580f 100644 --- a/sys/contrib/device-tree/Bindings/net/ethernet-phy.yaml +++ b/sys/contrib/device-tree/Bindings/net/ethernet-phy.yaml @@ -158,6 +158,27 @@ properties: Mark the corresponding energy efficient ethernet mode as broken and request the ethernet to stop advertising it. + timing-role: + $ref: /schemas/types.yaml#/definitions/string + enum: + - forced-master + - forced-slave + - preferred-master + - preferred-slave + description: | + Specifies the timing role of the PHY in the network link. This property is + required for setups where the role must be explicitly assigned via the + device tree due to limitations in hardware strapping or incorrect strap + configurations. + It is applicable to Single Pair Ethernet (1000/100/10Base-T1) and other + PHY types, including 1000Base-T, where it controls whether the PHY should + be a master (clock source) or a slave (clock receiver). + + - 'forced-master': The PHY is forced to operate as a master. + - 'forced-slave': The PHY is forced to operate as a slave. + - 'preferred-master': Prefer the PHY to be master but allow negotiation. + - 'preferred-slave': Prefer the PHY to be slave but allow negotiation. + pses: $ref: /schemas/types.yaml#/definitions/phandle-array maxItems: 1 @@ -211,6 +232,22 @@ properties: PHY's that have configurable TX internal delays. If this property is present then the PHY applies the TX delay. + tx-amplitude-100base-tx-percent: + description: + Transmit amplitude gain applied for 100BASE-TX. 100% matches 2V + peak-to-peak specified in ANSI X3.263. When omitted, the PHYs default + will be left as is. + + mac-termination-ohms: + maximum: 200 + description: + The xMII signals need series termination on the driver side to match both + the output driver impedance and the line characteristic impedance, to + prevent reflections and EMI problems. Select a resistance value which is + supported by the builtin resistors of the PHY, otherwise the resistors may + have to be placed on board. When omitted, the PHYs default will be left as + is. + leds: type: object |