1 files changed, 0 insertions, 70 deletions
diff --git a/sys/mips/conf/TL-ARCHERC7V2 b/sys/mips/conf/TL-ARCHERC7V2
deleted file mode 100644
index 053271fa133c..000000000000
--- a/sys/mips/conf/TL-ARCHERC7V2
+++ /dev/null
@@ -1,70 +0,0 @@
-#
-# TP-Link Archer C7 - based on the AP135 reference design.
-#
-# This contains a QCA9558 MIPS74k SoC with on-board 3x3 2GHz wifi,
-# 128MiB RAM, an AR8327 5-port gigabit ethernet switch and
-# a QCA 11ac 5GHz AP NIC.
-#
-# The to things not currently support are the QCA 11ac NIC and
-# PCIe host controllers - there's two of them, and the existing
-# PCIe code here doesn't support that just yet.
-#
-# $FreeBSD$
-#
-
-#NO_UNIVERSE
-
-# Include the default QCA955x parameters
-include         "std.QCA955X"
-
-ident           TL-ARCHERC7V2
-
-# Override hints with board values
-hints           "TL-ARCHERC7V2.hints"
-
-# Force the board memory - this has 128MiB RAM
-options         AR71XX_REALMEM=(128*1024*1024)
-
-# i2c GPIO bus
-#device		gpioiic
-#device		iicbb
-#device		iicbus
-#device		iic
-
-# Options required for miiproxy and mdiobus
-options 	ARGE_MDIO	# Export an MDIO bus separate from arge
-device		miiproxy	# MDIO bus <-> MII PHY rendezvous
-
-device		etherswitch
-device		arswitch
-
-# read MSDOS formatted disks - USB
-options 	MSDOSFS
-
-# Enable the uboot environment stuff rather then the
-# redboot stuff.
-options 	AR71XX_ENV_UBOOT
-
-# uzip - to boot natively from flash
-device		xz
-options 	GEOM_UZIP
-
-# Used for the static uboot partition map
-device          geom_map
-
-# yes, this board has a PCIe connected atheros device
-# add ath_pci so it can at least attach things when there's a
-# ath(4) in there, rather than the 11ac chip we don't support.
-device		pci
-device		qca955x_pci
-
-device		ath_pci
-options 	AR71XX_ATH_EEPROM
-device		firmware		# Used by the above
-options 	ATH_EEPROM_FIRMWARE
-
-# Boot off of the rootfs, as defined in the geom_map setup.
-options 	ROOTDEVNAME=\"ufs:map/rootfs.uzip\"
-
-# Default to accept
-options		IPFIREWALL_DEFAULT_TO_ACCEPT