diff options
Diffstat (limited to 'sys/mips/conf/std.AR_MIPS_BASE')
-rw-r--r-- | sys/mips/conf/std.AR_MIPS_BASE | 92 |
1 files changed, 0 insertions, 92 deletions
diff --git a/sys/mips/conf/std.AR_MIPS_BASE b/sys/mips/conf/std.AR_MIPS_BASE deleted file mode 100644 index ab0947a391ea..000000000000 --- a/sys/mips/conf/std.AR_MIPS_BASE +++ /dev/null @@ -1,92 +0,0 @@ -# These are the base base bits shared between all of the various Atheros -# MIPS bases. -# -# This allows a shared set of configuration and drivers to be built for -# all of the Atheros MIPS platforms without a lot of configuration file -# duplication. -# -# $FreeBSD$ - -# debugging -options EARLY_PRINTF -options ALT_BREAK_TO_DEBUGGER - -# For small memory footprints -options VM_KMEM_SIZE_SCALE=1 -options UMTX_CHAINS=16 -options NBUF=128 -# Don't include the SCSI/CAM strings in the default build -options SCSI_NO_SENSE_STRINGS -options SCSI_NO_OP_STRINGS -# .. And no sysctl strings -options NO_SYSCTL_DESCR - -makeoptions MODULES_OVERRIDE+="gpio ar71xx if_gif if_vlan if_gre if_tuntap" -makeoptions MODULES_OVERRIDE+="if_bridge bridgestp usb" -makeoptions MODULES_OVERRIDE+="alq" - -# net80211 -options IEEE80211_DEBUG -options IEEE80211_SUPPORT_MESH -options IEEE80211_SUPPORT_TDMA -options IEEE80211_SUPPORT_SUPERG -options IEEE80211_ALQ # 802.11 ALQ logging support - -makeoptions MODULES_OVERRIDE+="wlan wlan_xauth wlan_acl wlan_wep" -makeoptions MODULES_OVERRIDE+="wlan_tkip wlan_ccmp wlan_rssadapt wlan_amrr" - -# firewalling -options IPFIREWALL_DEFAULT_TO_ACCEPT - -makeoptions MODULES_OVERRIDE+="ipfw ipfw_nat libalias ipfw_nptv6" - -# USB wifi device drivers -makeoptions MODULES_OVERRIDE+="rtwn rtwn_usb rtwnfw" -makeoptions MODULES_OVERRIDE+="otus otusfw" - -# Atheros wifi device drivers -options ATH_DEBUG -options ATH_DIAGAPI -options ATH_ENABLE_11N -options ATH_ENABLE_DFS - -options AH_DEBUG_ALQ -options AH_DEBUG -options AH_AR5416_INTERRUPT_MITIGATION -options AH_RXCFG_SDMAMW_4BYTES - -makeoptions MODULES_OVERRIDE+="ath_main ath_pci ath_ahb ath_rate ath_dfs" -makeoptions MODULES_OVERRIDE+="ath_hal_ar5210 ath_hal_ar5211" -makeoptions MODULES_OVERRIDE+="ath_hal_ar5212 ath_hal_ar5416" -makeoptions MODULES_OVERRIDE+="ath_hal_ar9300 ath_hal" - -# USB configuration -options USB_EHCI_BIG_ENDIAN_DESC # handle big-endian byte order -options USB_DEBUG -options USB_HOST_ALIGN=32 # AR71XX (MIPS in general?) requires this - -# Ethernet configuration -device mii -device arge -options ARGE_DEBUG - -# SPI, flash -device spibus -device ar71xx_spi -device mx25l -device ar71xx_wdog - -# Serial driver -device uart - -# Networking -device loop -device ether -device md -device bpf -#device if_bridge - -# GPIO - normally it's okay as a module -#device gpio -#device gpioled - |