aboutsummaryrefslogtreecommitdiff
path: root/sys/dev/uart/uart_dev_mtk.c
Commit message (Collapse)AuthorAgeFilesLines
* uart: Add MediaTek UART driverHayzam Sherif3 days1-0/+407
The MediaTek UART is a 16550 with 32-bit spaced registers and a fractional baud rate generator. The driver gives that generator to the ns8250 code through its set_baudrate, get_baudrate and get_divisor functions, and uses the ns8250 code for everything else. The low-level console uses the ns8250 code too, so it keeps the rate the firmware set. For the 30 MHz clock of Table 2-6 of the reference manual [1], the divisor, SAMPLE_COUNT, SAMPLE_POINT and the number of extended bits are the table's, except at 7200 baud, where one extended bit is closer than the table's two. Rates that need fewer than 8 samples per bit are rejected: below that, the manual requires guard time from the sender. Probe enables the clocks while it runs, attach applies the assigned clocks and enables them, and detach releases them. The console is probed on the clocks the firmware left running and keeps its clocks on detach. Until there is an MT7986 pinctrl driver, UART1 and UART2 rely on the firmware's pin setup. [1] MT7986A Reference Manual for BPI-R3, v1.0, section 2.6, Tables 2-5 and 2-6. Distributed by Banana Pi: https://wiki.banana-pi.org/Banana_Pi_BPI-R3 Reviewed by: mmel Approved by: markj (mentor) Sponsored by: Alchemilla Ventures Private Limited Differential Revision: https://reviews.freebsd.org/D61191